Virtual Stacking – Router Switch Blog

Configuring High Availability on Virtual Stacking

Posted on June 29, 2018 by RouterSwitch Tech | 0 Comments

A switch can be configured as a standby commander for a cluster to make sure of continued manageability of the cluster switches in case a commander switch fails. The standby switch will take over only in a situation in which…

How to Configure a Virtual Stack on Cisco Catalyst 2960-L?

Posted on June 29, 2018 by RouterSwitch Tech | 0 Comments

Configuring Virtual Stacking We have gone through the virtual stacking technology before (Virtual Stacking and Associated Terminologies), its benefits, and how it differs from FlexStack technology on Cisco Catalyst 2960-X Series Switches (FlexStack vs. Virtual Stacking), In this article, we…

FlexStack vs. Virtual Stacking

Posted on June 28, 2018 by RouterSwitch Tech | 0 Comments

Differences between FlexStack and virtual stacking Cisco Catalyst 2960 users may be familiar with FlexStack tech on Cisco Catalyst 2960-X/XR Series and the virtual stacking tech on the 2960-L. (The Cisco Catalyst 2960 family of switches, namely, the Cisco Catalyst…

Requirements for Virtual Stacking

Posted on June 28, 2018 by RouterSwitch Tech | 0 Comments

The Catalyst 2960-L does not support stacking. But the Catalyst 2960-L switches support virtual stacking for single IP management. Up to eight switches can be configured and managed a single IP address. What’s the Virtual Stacking? And what are the…