IPSec – Router Switch Blog

Steps to Configure Static NAT with Route-maps

Posted on August 12, 2013 by RouterSwitch Tech | 0 Comments

A static NAT (Network Address Translation) configuration creates a simple translation entry in the NAT table, translating a particular local address to a specific global address and vice versa. These entries always remain in the table and are removed only if…

Site-to-Site IPSEC VPN between Two Cisco ASA 5520

Posted on March 25, 2013 by RouterSwitch Tech | 0 Comments

Cisco ASA 5500 Series appliances deliver IPsec and SSL VPN, firewall, and several other networking services on a single platform. Cisco ASA 5520, a member of the Cisco ASA 5500 Series, is shown in Figure 1 below. Figure 1 Cisco…

What’s the Order of Operations for Cisco IOS?

Posted on January 15, 2013 by RouterSwitch Tech | 0 Comments

“What’s the order in which IOS processes the running config between the following items? ACL Distrubute list, Route map Routing Protocol Routing What im looking for is the packet flow when it arrives thru an interface for better understanding? Does…

How to Set Up IPSec Direct Encapsulation on Cisco Devices?

Posted on October 10, 2012 by RouterSwitch Tech | 0 Comments

With the importance of internet security being at the forefront of everyone’s mind these days, importance of keeping data safe while in transit is vital. There are of course a number of different technologies that are available to keep data…